Aluminum alloy folding door is a door made of aluminum alloy. It has the advantages of beautiful appearance, easy cleaning, and space saving, and it is loved by many families. The aluminum alloy folding door is composed of door frame, door leaf, transmission parts, rotating arm parts, transmission rod, orientation device, etc. The aluminum alloy folding door accessories mainly include hinges, upper slides, rotating shafts, transmissions and other hardware. To install the aluminum alloy folding door, you need to determine the position first, then insert the folding door, insert the rubber sleeve after fixing it, and then fix the iron absorption plate. Let’s take a look at aluminum alloy folding doors!
What is aluminum alloy folding door
Folding door is a new type of door that can be folded and pushed to the side after opening. Aluminum alloy folding door is a folding door made of aluminum alloy. Aluminum alloy folding doors are not only beautiful and generous, but also diverse in styles, easy to use, and can save the occupied area of the door. They are used in small-sized kitchens, bathrooms and other areas. The kitchen and bathroom areas are relatively humid and high-temperature areas. In addition, aluminum alloy folding doors have the characteristics of heat preservation and moisture resistance. Therefore, aluminum alloy folding doors are a good choice for kitchen and bathroom areas.
Aluminum alloy folding doors are mainly composed of door frames, door leaves, transmission parts, rotating arm parts, transmission rods, and orientation devices. This door type can be installed indoors and outdoors, each door has four doors, two side doors and two middle doors.
What are the aluminum alloy folding door accessories
Generally, the hardware accessories of indoor aluminum alloy folding doors mainly include hinges, upper slides, rotating shafts, actuators, handles, latches, fixed runners, decorative pieces, etc. The profiles need to be matched with the hardware notches.
How to install aluminum alloy folding door
1. Determine the location
First of all, we must determine the installation location before installing the folding door. If it is used as a kitchen door or toilet door, it should be installed in the middle of the door frame; if it is used as a partition in the living room, determine the location, leave a corresponding space, and measure the straight line Length, and then confirm whether the length of the track is correct. If the track is relatively long, use a ruler to measure the length of use, make a mark, and use a hacksaw to saw off the growing part. Be careful not to let iron filings fall into the track, so as not to affect The sliding of the door.
2. Insert the folding door
Pick up the slideway, insert the aluminum alloy folding door into the slideway in the bundled state, and push it to the middle part of the slideway. The bundled state is more convenient for installation. Pushing it to the middle is to prevent accidental sliding during installation. Fall off the slide.
3. Fixed
Before fixing, confirm the direction of the handle, whether you are accustomed to pulling left or right, choose the appropriate direction according to your habit, and start installing the track after confirmation, install in the order of the middle and then the two sides, and use the impact drill to screw the screw into the track And the door frame or wall, because the door frame or wall is relatively thick, it is difficult to screw in the screws with a screwdriver alone, so use the power of an impact drill to untie the rope that binds the folding door after installing the screws.
4. Into the rubber sleeve
Pull the folding door open, compare the position of the magnet on the door to determine the position of the iron absorption plate on the wall or door frame. After determining the position of each iron absorption plate, drill a hole with a percussion drill to a depth of about four centimeters, and then Punch the rubber sleeve into the hole, and then push the rubber sleeve in one by one.
5. Fix the iron suction plate
Push the aluminum alloy folding door to the middle again, pick up the iron suction plate, align the hole on it with the hole of the rubber sleeve, and use a screwdriver to screw the screw into the rubber sleeve until the suction plate is fixed. The iron absorption plates are all fixed, and then the folding door is opened, and the side without the handle is sucked with the iron absorption plates, and the installation is completed.
